CI Systems ControlMaster SR-800R - Disassembling the System; Shutting down the System; Draining the Fluid from the Blackbody

CI Systems SR-800R
8.5 Disassembling the System
The sequence in disassembling the system is:
 Shutting Down the System (see Section 8.5.1)
 Draining the Fluid from the Blackbody (see Section 8.5.2)
 Disconnecting the Pipes from the Blackbody (see Section 8.5.3)
 Disconnecting the Dry Nitrogen Source and Cables (see Section 8.5.4)
 Packing (see Section 8.5.5)
8.5.1 Shutting Down the System
1. Switch the SR-800R Controller OFF.
2. Switch OFF both Julabo Circulation System switches (refer to the Julabo
Circulation System Operating Manual).
8.5.2 Draining the Fluid from the Blackbody
1. Drain the fluid from the Julabo Circulation System fluid tank (refer to the Julabo
Circulation System Operating Manual).
2. Disconnect one of the pipes from the Julabo Circulation System. Using a high-
pressurized air hose and hand piece, force all the cooling fluid out of the pipes and
into the fluid tank.
3. Release and remove the Pipes from the Julabo Circulation System using a 19 mm
open-wrench (see Figure 8-8).
605-7040 Operation Manual
Rev D 8-17
June 2013
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com