CI Systems SR-800R
c. Change settings as shown in Figure 3-44:
Figure 3-44: Setting Up the Internet Protocol (TCP/IP)
d. Click when completed.
The Host Computer is now setup with an IP Address compatible with the SR-
800R.
4. Connect the Direct Link Cable between the Ethernet Output Socket on the Host
Computer with the LAN Output socket on the SR-800R.
You should now be able to communicate directly with the SR-800R.
NOTE
To restore to the original settings, on the Host Computer, set
the TCP/IP Properties back to Obtain an IP Address
Automatically and on the SR-800R restore the Communication
Type that was active, such as, GPIB, or RS232 etc via the
Communications Setup window.
605-7040 Operation Manual
Rev D 3-42
June 2013
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...