CI Systems ControlMaster SR-800R - Setmode

CI Systems SR-800R
Command Category Description Remarks
CM
2
Set Temperature
Control Operating
Mode.
See SETMODE
GETMODE Get Current
Temperature Control
Mode.
GETTARGETTEMPERATURE Get Current Target
Temperature.
Replaces RT
GETTEMPERATURE Get the current
temperature
measurement per the
current Temperature
Control Mode.
GETTEMPERATURERANGE Get the Absolute and
Differential Working
Temperature Range of
the Controller.
Replaces RG
RG
2
Get the Absolute and
Differential Working
Temperature Range of
the Controller
depending on the
current temperature
mode.
See
GETTEMPERATURERANGE
ISTEMPERATURESTABLE Monitor Whether
Temperature is within
stable Setpoint
conditions.
RD
2
Get Current Differential
Temperature.
RE
2
Get Current Emitter or
Absolute Temperature.
RT
2
Get Current Target
Temperature.
See
GETTARGETTEMPERATURE
SETMODE Set Temperature
Control Operating
Mode.
Replaces CM
605-7040 Operation Manual
Rev D 6-5
June 2013
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com