CI Systems ControlMaster SR-800R - Echo

CI Systems SR-800R
6.2.13 CM
 Summary: This command sets the Temperature Control Mode.
 Note: This command may take some time. Allow at least 1-2 seconds before
checking the mode with the GetMode Command.
NOTE
This is an Old Style Command that is used for downward
compatibility to CI’s SR80 BlackBody Controllers. NOT
Recommended For Use - see the SETMODE command
(Section 6.2.1) for replacement.
C M
Space
Mode
EOM
 SR-80 command format compliance.
 Input Operand: Mode
• 1 = Absolute
• 2 = Differential
• 3 = Differential with Radiometric Offset Correction
 Return Values: None.
6.2.14 ECHO
 Summary: This command is used to check that the unit is communicating. It
echoes the received input message back to the Host.
E C H O
Space
Message String
EOM
 Input Operand: Message String - to be echoed back to the Host. The maximum
length should not exceed 100 characters.
 Return Values: Returns the message string.
605-7040 Operation Manual
Rev D 6-17
June 2013
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com