CI Systems SR-800R
5. To Enable/Disable working with an Head (for example, using the SR-800R as a
motion-controller only):
a. Select/deselect the Head Enable checkbox. When disabled the Head is
disconnected from the Blackbody and only the Motion Control is active in the
system.
b. Upon selection, the following opens prompting you to re-boot the SR-800R:
c. Confirm the parameter updates by pressing Yes.
Figure 3-40: Reboot Message
d. Turn the SR-800R OFF and ON. Note that the display of the Main and Menu
windows has been changed.
6. Press
to update the settings in the system.
7. To close and return to the last opened window (the Options window) press .
8. To close and return to the Main window press .
605-7040 Operation Manual
Rev D 3-38
June 2013
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...