CI Systems SR-800R
Motorized Stages: the SR-800R Controller can operate and control up to four
stepper-motors. One of the implementations of a motion-controlled device is the
motorized stage.
I/O Devices: the SR-800R Controller can drive up to five output devices (24V,
100mA), and monitor two input devices (TTL-to-24V).
Communication Protocols: the SR-800R Controller is equipped with several
communication protocols (to be used either when the SR-800R Controller is
integrated as part of an EO (Electro-Optic) test system, or when it is connected to
a local network). Only one protocol can be active. The communication protocols
are:
• LAN: standard LAN Ethernet communication port: may be used when the
SR-800R Controller operates under the control of a host computer, either
directly or via the computer network.
• RS232: standard RS232 communication port: may be used when the SR-800R
Controller operates under the control of a host computer, or operates under the
control of the EO Test System computer.
• GPIB: standard GPIB communication port, may be used when the SR-800R
Controller operates under the control of a host computer, or operates under the
control of the EO Test System computer.
605-7040 Operation Manual
Rev D 2-2
June 2013
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...