CI Systems ControlMaster SR-800R - Page 12

CI Systems SR-800R
Figure 3-18: MRTD - Typical 4-Bar Targets ............................................................................3-20
Figure 3-19: MRTD Test ...........................................................................................................3-21
Figure 3-20: MRTD Test Setup (1 of 5) ....................................................................................3-22
Figure 3-21: MRTD Test Setup (2 of 5) ....................................................................................3-22
Figure 3-22: MRTD Test Setup (3 of 5) ....................................................................................3-23
Figure 3-23: MRTD Test Setup (4 of 5) ....................................................................................3-24
Figure 3-24: MRTD Test Setup (5 of 5) ....................................................................................3-24
Figure 3-25: MRTD Test Run....................................................................................................3-25
Figure 3-26: MRTD Test Results Chart ....................................................................................3-26
Figure 3-27: MRTD Test Results Table ....................................................................................3-26
Figure 3-28: Password ...............................................................................................................3-27
Figure 3-29: Options ..................................................................................................................3-27
Figure 3-30: Motion Setup.........................................................................................................3-28
Figure 3-31: Axis Setup.............................................................................................................3-28
Figure 3-32: Target Setup ..........................................................................................................3-30
Figure 3-33: Target Setup - Type Pull-Down Menu..................................................................3-30
Figure 3-34: Alphanumeric Keypad ..........................................................................................3-31
Figure 3-35: Saving New Settings .............................................................................................3-31
Figure 3-36: Adding a New Target to the Target List ...............................................................3-33
Figure 3-37: Target Removal.....................................................................................................3-34
Figure 3-38: Target Type/Tuning ..............................................................................................3-34
Figure 3-39: Settings..................................................................................................................3-36
Figure 3-40: Reboot Message ....................................................................................................3-38
Figure 3-41: Communications Setup .........................................................................................3-39
Figure 3-42: Communications Setup (Direct LAN setup).........................................................3-40
Figure 3-43: Setting Up the Host Computer for Direct Link.....................................................3-41
Figure 3-44: Setting Up the Internet Protocol (TCP/IP)............................................................3-42
Figure 3-45: Re-Store Factory Defaults.....................................................................................3-43
Figure 3-46: Absolute Temperature Setting ..............................................................................3-44
Figure 3-47: Differential Temperature Setting ..........................................................................3-45
Figure 3-48: Temperature Display Resolution Setting ..............................................................3-45
Figure 3-49: About.....................................................................................................................3-47
Figure 3-50: Changing the Controller Name (1 of 3) ................................................................3-47
Figure 3-51: Changing the Controller Name (2 of 3) ................................................................3-48
Figure 3-52: Changing the Controller Name (3 of 3) ................................................................3-48
Figure 4-1: Portable Configuration............................................................................................4-2
Figure 4-2: Connectors ..............................................................................................................4-3
Figure 4-3: 19" Rack Mount Configuration (typical) ................................................................4-4
Figure 5-1: Fuse Replacement ...................................................................................................5-8
605-7040 Operation Manual
Rev D xi
June 2013
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com