CI Systems SR-800R
Motion Control Card (MCC):
used to control and drive up to four stepper-motors.
AC/DC Converter Card (ACDC):
used to convert the Mains input power (110V/220VAC) into ±45VDC. Two card
grades are available (grades A and C). The grades differ in their throughput-
power. Compatibility is required between the card grade and Blackbody
type/model.
Power Amplifier Card (PA):
provides a controlled power to the Blackbody (depending on the Blackbody type).
The PA is powered by the AC/DC Converter Card.
Two card grades are available (grades A and C). The grades differ in their
throughput-power. Compatibility is required between the card grade and
Blackbody type/model.
Temperature Sensor Card (TSC):
located in the Blackbody. The card is used to sense the Blackbody temperature, to
store the BB temperature calibration data, to store the BB identification data
(Model, S/N, etc.), and to interface with the SR-800R Controller.
605-7040 Operation Manual
Rev D 2-13
June 2013
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...