CI Systems ControlMaster SR-800R - Page 81

CI Systems SR-800R
3. Enter the Slow and Fast arrow Increments (any decimal value).
4. Enter the Stabilization Window values.
NOTES
- The Slow Increments value must be lower than the Fast value.
- It is recommended that the Stabilization Window value should
be higher than the Display Resolution value.
- The Slow Increment value must be higher than the Display
Resolution value.
- The dT MRTD field is used for MRTD stabilization only.
5. To restore the temperature window values press (the default values are
as shown in Figure 3-47).
6. Press
to update the settings in the system.
7. To close and return to the last opened window (the Options window) press .
8. To close and return to the Main window press .
605-7040 Operation Manual
Rev D 3-46
June 2013
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com