46-126
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E
OL_28731-01
Chapter 46 Configuring 802.1X Port-Based Authentication
Displaying 802.1X Statistics and Status
The following example shows how to apply a CDP TLV filter list to the Device Sensor output:
Switch> enable
Switch# configure terminal
Switch(config)# device-sensor filter-spec cdp include cdp-list1
The following example shows how to enable client notifications and accounting events for all TLV
changes:
Switch> enable
Switch# configure terminal
Switch(config)# device-sensor notify all-changes
Displaying 802.1X Statistics and Status
To display 802.1X statistics for all interfaces, use the show dot1x all statistics privileged EXEC
command.
To display the 802.1X administrative and operational status for the switch, use the
show dot1x all details privileged EXEC command. To display the 802.1X administrative and
operational status for a specific interface, use the show dot1x interface details privileged EXEC
command.
Displaying Authentication Details
This section includes these topics:
• Determining the Authentication Methods Registered with the Auth Manager, page 46-126
• Displaying the Auth Manager Summary for an Interface, page 46-127
• Displaying the Summary of All Auth Manager Sessions on the Switch, page 46-127
• Displaying a Summary of All Auth Manager Sessions on the Switch Authorized for a Specified
Authentication Method, page 46-127
• Verifying the Auth Manager Session for an Interface, page 46-127
• Displaying MAB Details, page 46-129
• EPM Logging, page 46-130
Determining the Authentication Methods Registered with the Auth Manager
This example show how to display the registered authentication methods:
Enter the following:
Switch# show authentication registrations
Handle Priority Name
3 0 dot1x
2 1 mab
1 2 webauth
To Next Page
Loading...
