EasyManuals Logo

Cisco Catalyst 4500 Series Administration Guide

Cisco Catalyst 4500 Series
1814 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1459 background imageLoading...
Page #1459 background image
CHAPTER
57-1
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E
OL_28731-01
57
Configuring Storm Control
This chapter describes how to configure port-based traffic control on the Catalyst 4500 series switch.
This chapter consists of these sections:
• About Storm Control, page 57-1
• Enabling Broadcast Storm Control, page 57-3
• Enabling Multicast Storm Control, page 57-4
• Disabling Broadcast Storm Control, page 57-5
• Disabling Multicast Storm Control, page 57-5
• Displaying Storm Control, page 57-6
Note For complete syntax and usage information for the switch commands used in this chapter, see the Cisco
Catalyst 4500 Series Switch Command Reference and related publications at this location:
http://www.cisco.com/en/US/products/hw/switches/ps4324/index.html
If a command is not in the Catalyst 4500 Series Switch Command Reference, you can locate it in the
Cisco IOS library. See the Cisco IOS Command Reference and related publications at this location:
http://www.cisco.com/en/US/products/ps6350/index.html
About Storm Control
This section contains the following subsections:
• Hardware-Based Storm Control Implementation, page 57-2
• Software-Based Storm Control Implementation, page 57-2
Storm control prevents LAN interfaces from being disrupted by a broadcast storm. A broadcast storm
occurs when broadcast packets flood the subnet, creating excessive traffic and degrading network
performance. Errors in the protocol-stack implementation or in the network configuration can cause a
broadcast storm.

Table of Contents

Other manuals for Cisco Catalyst 4500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 4500 Series and is the answer not in the manual?

Cisco Catalyst 4500 Series Specifications

General IconGeneral
SeriesCatalyst 4500 Series
CategorySwitch
Layer SupportLayer 2, Layer 3
Form FactorModular chassis
StackableNo
Chassis Slots3, 6, 7, 10
Power Supply OptionsAC, DC
RedundancyPower supply, Supervisor engine
Network ManagementCisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
FeaturesSecurity, QoS
Port DensityUp to 384 ports per chassis
Security Features802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine8-E

Related product manuals