Cisco Catalyst 4500 Series - Verifying WCCP Settings Example

72-12
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E
OL_28731-01
Chapter 72 Configuring WCCP Version 2 Services
WCCP Configuration Examples
Verifying WCCP Settings Example
To verify your configuration changes, use the more system:running-config EXEC command. The
following example shows that the both the web cache service and dynamic service 99 are enabled on the
Catalyst 4500 series switch:
WCCP unicast mode
Switch# more system:running-config
Building configuration...
Current configuration:
!
version 12.2
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
service udp-small-servers
service tcp-small-servers
! !
enable secret 5 $1$nSVy$faliJsVQXVPW.KuCxZNTh1
enable password alabama1
!
ip subnet-zero
ip wccp web-cache
ip wccp 99
!
interface Vlan200
ip address 10.3.1.2 255.255.255.0
ip wccp web-cache redirect in
interface Vlan300
ip address 10.4.1.1 255.255.255.0
ip wccp redirect exclude in
interface Vlan400
ip address 10.5.1 255.255.255.0
ip wccp 99 redirect out
ip default-gateway 10.3.1.1
ip classless
ip route 0.0.0.0 0.0.0.0 10.3.1.1
no ip http server
!
!
WCCP multicast mode
ip wccp web-cache group-address 224.1.1.1
ip wccp 60 group-address 224.1.1.1
ip wccp 90
ip wccp 91
interface Vlan70
ip address 70.1.1.1 255.255.255.0
ip wccp web-cache group-listen
ip wccp 60 group-listen
ip wccp redirect exclude in