EasyManuals Logo

Cisco Catalyst 4500 Series Administration Guide

Cisco Catalyst 4500 Series
1814 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #487 background imageLoading...
Page #487 background image
CHAPTER
13-1
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E
OL_28731-01
13
Environmental Monitoring and Power
Management
Note Before reading this chapter, read the “Preparing for Installation” section of the
Catalyst 4500 Series Installation Guide. It is important to ensure that your installation site has enough
power and cooling to accommodate the additional electrical load and heat introduced by Power over
Ethernet (PoE).
This chapter describes power management and environmental monitoring features in the Catalyst 4500
series switches. It provides guidelines, procedures, and configuration examples.
This chapter consists of the following major sections:
About Environmental Monitoring, page 13-1
Power Management, page 13-7
IEEE 802.3az Energy Efficient Ethernet, page 13-23
Note For complete syntax and usage information for the switch commands used in this chapter, see the Cisco
Catalyst 4500 Series Switch Command Reference and related publications at this location:
http://www.cisco.com/en/US/products/hw/switches/ps4324/index.html
If a command is not in the Catalyst 4500 Series Switch Command Reference, you can locate it in the
Cisco IOS library. See the Cisco IOS Command Reference and related publications at this location:
http://www.cisco.com/en/US/products/ps6350/index.html
About Environmental Monitoring
This section contains the following subsections:
Using CLI Commands to Monitor your Environment, page 13-2
Displaying Environment Conditions, page 13-2
Displaying On Board Failure Logging (OBFL) information for 9000W AC, page 13-4
Emergency Actions, page 13-5

Table of Contents

Other manuals for Cisco Catalyst 4500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 4500 Series and is the answer not in the manual?

Cisco Catalyst 4500 Series Specifications

General IconGeneral
SeriesCatalyst 4500 Series
CategorySwitch
Layer SupportLayer 2, Layer 3
Form FactorModular chassis
StackableNo
Chassis Slots3, 6, 7, 10
Power Supply OptionsAC, DC
RedundancyPower supply, Supervisor engine
Network ManagementCisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
FeaturesSecurity, QoS
Port DensityUp to 384 ports per chassis
Security Features802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine8-E

Related product manuals