Cisco Catalyst 4500 Series Administration Guide

34-7
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E
OL_28731-01
Chapter 34 Configuring Layer 3 Interfaces
Configuring VLANs as Layer 3 Interfaces
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
Switch#
This example shows how to use the show running-config command to display the interface IP address
configuration of Layer 3 VLAN interface VLAN 2:
Switch# show running-config
Building configuration...
Current configuration : !
interface Vlan2
ip address 10.1.1.1 255.255.255.248
!
ip classless
no ip http server
!
!line con 0
line aux 0
line vty 0 4
!
end
Configuring VLANs as Layer 3 Interfaces
This section consists of the following subsections:
• Configuring SVI Autostate Exclude, page 34-7
• Configuring IP MTU Sizes, page 34-9
• Configuring Layer 3 Interface Counters, page 34-10
Configuring SVI Autostate Exclude
Note The SVI Autostate Exclude feature is enabled by default and is synchronized with the STP state.
The SVI Autostate Exclude feature shuts down (or brings up) the Layer 3 interfaces of a switch when
the following port configuration changes occur:
• When the last port on a VLAN goes down, the Layer 3 interface on that VLAN is shut down
(SVI- autostated).
• When the first port on the VLAN is brought back up, the Layer 3 interface on the VLAN that was
previously shut down is brought up.
SVI Autostate Exclude enables you to exclude the access ports and trunks in defining the status of the
SVI (up or down) even if it belongs to the same VLAN. If the excluded access port and trunk is in up
state and other ports are in down state in the VLAN, the SVI state is changed to down.
To make the SVI state up, at least one port in the VLAN should be up and not excluded. This action helps
to exclude the monitoring port status when you are determining the status of the SVI.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E