EasyManuals Logo

Cisco Catalyst 4500 Series Administration Guide

Cisco Catalyst 4500 Series
1814 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #885 background imageLoading...
Page #885 background image
CHAPTER
37-1
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E
OL_28731-01
37
Configuring IP Multicast
This chapter describes IP multicast routing on the Catalyst 4500 series switch. It also provides
procedures and examples to configure IP multicast routing.
Note For more detailed information on IP Multicast, refer to this URL:
http://www.cisco.com/en/US/products/ps6552/products_ios_technology_home.html
Note For complete syntax and usage information for the switch commands used in this chapter, see the Cisco
Catalyst 4500 Series Switch Command Reference and related publications at this location:
http://www.cisco.com/en/US/products/hw/switches/ps4324/index.html
If a command is not in the Catalyst 4500 Series Switch Command Reference, you can locate it in the
Cisco IOS library. See the Cisco IOS Command Reference and related publications at this location:
http://www.cisco.com/en/US/products/ps6350/index.html
This chapter includes the following major sections:
• About IP Multicast, page 37-1
• Configuring IP Multicast Routing, page 37-13
• Monitoring and Maintaining IP Multicast Routing, page 37-23
• Configuration Examples, page 37-28
About IP Multicast
Note Controlling the transmission rate to a multicast group is not supported.
At one end of the IP communication spectrum is IP unicast, where a source IP host sends packets to a
specific destination IP host. In IP unicast, the destination address in the IP packet is the address of a
single, unique host in the IP network. These IP packets are forwarded across the network from the source

Table of Contents

Other manuals for Cisco Catalyst 4500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 4500 Series and is the answer not in the manual?

Cisco Catalyst 4500 Series Specifications

General IconGeneral
SeriesCatalyst 4500 Series
CategorySwitch
Layer SupportLayer 2, Layer 3
Form FactorModular chassis
StackableNo
Chassis Slots3, 6, 7, 10
Power Supply OptionsAC, DC
RedundancyPower supply, Supervisor engine
Network ManagementCisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
FeaturesSecurity, QoS
Port DensityUp to 384 ports per chassis
Security Features802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine8-E

Related product manuals