EasyManuals Logo

Cisco Catalyst 4500 Series Administration Guide

Cisco Catalyst 4500 Series
1814 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #169 background imageLoading...
Page #169 background image
CHAPTER
4-1
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E
OL-30933-01
4
Administering the Switch
This chapter describes how to perform one-time operations to administer the Catalyst 4500 Series
switch.
This chapter also describes how to install and configure the Embedded CiscoView network management
system to provide a graphical representation of a Catalyst 4500 series switch and to provide a GUI-based
management and configuration interface.
This chapter includes the following major sections:
• Managing the System Time and Date, page 4-1
• Managing Software Licenses Using Permanent Right-To-Use Features, page 4-14
• Configuring a System Name and Prompt, page 4-21
• Creating a Banner, page 4-24
• Managing the MAC Address Table, page 4-28
• Managing the ARP Table, page 4-44
• Configuring Embedded CiscoView Support, page 4-44
Note For complete syntax and usage information for the switch commands used in this chapter, see the Cisco
Catalyst 4500 Series Switch Command Reference and related publications at this location:
http://www.cisco.com/en/US/products/hw/switches/ps4324/index.html
If a command is not in the Catalyst 4500 Series Switch Command Reference, you can locate it in the
Cisco IOS library. See the Cisco IOS Command Reference and related publications at this location:
http://www.cisco.com/en/US/products/ps6350/index.html
Managing the System Time and Date
You can configure the system time and date on your switch manually or automatically by using Network
Time Protocol (NTP).
These sections contain this configuration information:
• System Clock, page 4-2
• Understanding Network Time Protocol, page 4-2

Table of Contents

Other manuals for Cisco Catalyst 4500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 4500 Series and is the answer not in the manual?

Cisco Catalyst 4500 Series Specifications

General IconGeneral
SeriesCatalyst 4500 Series
CategorySwitch
Layer SupportLayer 2, Layer 3
Form FactorModular chassis
StackableNo
Chassis Slots3, 6, 7, 10
Power Supply OptionsAC, DC
RedundancyPower supply, Supervisor engine
Network ManagementCisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
FeaturesSecurity, QoS
Port DensityUp to 384 ports per chassis
Security Features802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine8-E

Related product manuals