Cisco Catalyst 4500 Series Administration Guide

CHAPTER
20-1
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E
OL_28731-01
20
Configuring SmartPort Macros
This chapter describes how to configure and apply SmartPort and Static SmartPort macros on your
switch. This chapter consists of these sections:
• About SmartPort Macros and Static SmartPort, page 20-1
• Configuring SmartPort Macros, page 20-2
• Displaying SmartPort Macros, page 20-13
• Configuring Static SmartPort Macros, page 20-13
Note For complete syntax and usage information for the switch commands used in this chapter, see the Cisco
Catalyst 4500 Series Switch Command Reference and related publications at this location:
http://www.cisco.com/en/US/products/hw/switches/ps4324/index.html
If a command is not in the Catalyst 4500 Series Switch Command Reference, you can locate it in the
Cisco IOS library. See the Cisco IOS Command Reference and related publications at this location:
http://www.cisco.com/en/US/products/ps6350/index.html
About SmartPort Macros and Static SmartPort
SmartPort macros provide a convenient way to save and share common configurations. Use SmartPort
macros to enable features and settings based on the location of a switch in the network and for mass
configuration deployments across the network.
Each SmartPort macro is a set of CLI commands that you define. SmartPort macro sets do not contain
new CLI commands; each SmartPort macro is a group of existing CLI commands.
When you apply a SmartPort macro on an interface, the CLI commands contained within the macro are
configured on the interface. When the macro is applied to an interface, the existing interface
configurations are not lost. The new commands are added to interface and are saved in the running
configuration file.
In addition to SmartPort macros, static SmartPort macros provide port configuration that you manually
apply based on the device connected to the port. When you apply a static SmartPort macro the CLI
commands within the macro are added to the existing port configuration. When there is a link-down
event on the port, the switch does not remove the static macro.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E