Cisco Catalyst 4500 Series - Dynamic Port VLAN Membership Configuration Example

16-29
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E
OL_28731-01
Chapter 16 Configuring VLANs, VTP, and VMPS
VLAN Membership Policy Server
Dynamic Port VLAN Membership Configuration Example
Figure 16-4 on page 16-29 shows a network with a VMPS servers and VMPS client switches with
dynamic ports. In this example, these assumptions apply:
• The VMPS server and the VMPS client are separate switches.
• The Catalyst 4000 family Switch 1 (running Catalyst Operating System) is the primary VMPS
server.
• The Catalyst 6000 family Switch 3 (running Catalyst Operating System) and the URT are secondary
VMPS servers.
• End stations are connected to these clients:
– Catalyst 4500 series XL Switch 2 (running Catalyst Cisco IOS)
– Catalyst 4500 series XL Switch 9 (running Catalyst Cisco IOS)
• The database configuration file is called Bldg-G.db and is stored on the TFTP server with the IP
address 172.20.22.7.
Figure 16-4 Dynamic Port VLAN Membership Configuration
Primary VMPS
Server 1
Secondary VMPS
Server 2
Secondary VMPS
Server 3
172.20.26.150
172.20.26.151
Catalyst 4000
(CatOS)
Catalyst 6000
(CatOS)
URT
172.20.26.152
Ethernet segment
172.20.26.153
172.20.26.154
172.20.26.155
172.20.26.156
172.20.26.157
172.20.26.158
172.20.26.159
Client
Client
End
station 2
End
station 1
TFTP server
3/1
Switch 10
Switch 9
Switch 8
Switch 7
Switch 6
Switch 5
Switch 3
Switch 2
Switch 1
Switch 4
172.20.22.7
130105
Router