Cisco Catalyst 4500 Series - Configuring MIB Support

To Next Page

To Previous Page

CHAPTER

73-1

Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E

OL_28731-01

Configuring MIB Support

This chapter describes how to configure SNMP and MIB support for the Cisco 4500 series switch. It

includes the following sections:

• Determining MIB Support for Cisco IOS Releases, page 73-1

• Using Cisco IOS MIB Tools, page 73-2

• Downloading and Compiling MIBs, page 73-2

• Enabling SNMP Support, page 73-4

Note For complete syntax and usage information for the switch commands used in this chapter, see the Cisco

Catalyst 4500 Series Switch Command Reference and related publications at this location:

http://www.cisco.com/en/US/products/hw/switches/ps4324/index.html

If a command is not in the Catalyst 4500 Series Switch Command Reference, you can locate it in the

Cisco IOS library. See the Catalyst 4500 Series Switch Cisco IOS Command Reference and related

publications at this location:

http://www.cisco.com/en/US/products/ps6350/index.html

Determining MIB Support for Cisco IOS Releases

To determine which MIBs are included in the Cisco IOS release running on the Cisco 4500 series switch,

follow these steps:

Step 1 Go to the Cisco MIBs Support page:

http://www.cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml

Step 2 Under Cisco Access Products, select a Cisco 4500 switch to display a list of MIBs supported on the

Cisco 4500 switches.

Step 3 Scroll through the list to find the release you are interested in.

Other manuals for Cisco Catalyst 4500 Series