EasyManuals Logo

Cisco Catalyst 4500 Series Administration Guide

Cisco Catalyst 4500 Series
1814 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #837 background imageLoading...
Page #837 background image
CHAPTER
33-1
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E
OL_28731-01
33
Configuring Unidirectional Ethernet
Note Unidirectional Ethernet is not supported on the following: Catalyst 4900M, Catalyst 4948E, Supervisor
Engine 6-E, Supervisor Engine 6L-E, Supervisor Engine 7-E, and Supervisor Engine 7L-E uplinks.
This chapter describes how to configure Unidirectional Ethernet on the Catalyst 4000 family switch and
contains these sections:
• About Unidirectional Ethernet, page 33-1
• Configuring Unidirectional Ethernet, page 33-2
Note For complete syntax and usage information for the switch commands used in this chapter, see the Cisco
Catalyst 4500 Series Switch Command Reference and related publications at this location:
http://www.cisco.com/en/US/products/hw/switches/ps4324/index.html
If a command is not in the Catalyst 4500 Series Switch Command Reference, you can locate it in the
Cisco IOS library. See the Cisco IOS Command Reference and related publications at this location:
http://www.cisco.com/en/US/products/ps6350/index.html
About Unidirectional Ethernet
You can set stubless Gigabit Ethernet ports to unidirectionally transmit or receive traffic. Unidirectional
Ethernet uses only one strand of fiber for either transmitting or receiving one-way traffic for the Gigabit
Ethernet Port, instead of two strands of fiber for a full-duplex Gigabit Ethernet Port. Configuring your
Gigabit Ethernet Port either to transmit or receive traffic effectively doubles the amount of traffic
capabilities for applications, such as video streaming, where most traffic is sent as unacknowledged
unidirectional video broadcast streams.

Table of Contents

Other manuals for Cisco Catalyst 4500 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 4500 Series and is the answer not in the manual?

Cisco Catalyst 4500 Series Specifications

General IconGeneral
SeriesCatalyst 4500 Series
CategorySwitch
Layer SupportLayer 2, Layer 3
Form FactorModular chassis
StackableNo
Chassis Slots3, 6, 7, 10
Power Supply OptionsAC, DC
RedundancyPower supply, Supervisor engine
Network ManagementCisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
FeaturesSecurity, QoS
Port DensityUp to 384 ports per chassis
Security Features802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine8-E

Related product manuals