Cisco Catalyst 4500 Series Administration Guide

70-6
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E
OL_28731-01
Chapter 70 Configuring RMON
Displaying RMON Status
To collect group Ethernet statistics on an interface, perform this task:
Displaying RMON Status
To display the RMON status, use one or more of the following privileged EXEC commands:
Step 6
Switch# show rmon history
Displays the contents of the switch history table.
Step 7
Switch# copy running-config startup-config
(Optional) Saves your entries in the configuration file.
Command Purpose
Command Purpose
Step 1
Switch# configure terminal
Enters global configuration mode.
Step 2
Switch(config)# interface interface-id
Specifies the interface on which to collect statistics, and enter
interface configuration mode.
Step 3
Switch(config-if)# rmon collection stats
index
[owner ownername]
Enables RMON statistic collection on the interface.
• For index, specify the RMON group of statistics. The range
is from 1 to 65535.
• (Optional) For owner ownername, enter the name of the
owner of the RMON group of statistics.
To disable the collection of group Ethernet statistics, use the no
rmon collection stats index interface configuration command.
Step 4
Switch(config-if)# end
Returns to privileged EXEC mode.
Step 5
Switch# show running-config
Verifies your entries.
Step 6
Switch# show rmon statistics
Displays the contents of the switch statistics table.
Step 7
Switch# copy running-config startup-config
(Optional) Saves your entries in the configuration file.
Command Purpose
show rmon
Displays general RMON statistics.
show rmon alarms
Displays the RMON alarm table.
show rmon events
Displays the RMON event table.
show rmon history
Displays the RMON history table.
show rmon statistics
Displays the RMON statistics table.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E