Cisco Catalyst 4500 Series - Configuring Netflow-Lite

To Next Page

To Previous Page

CHAPTER

64-1

Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E

OL_28731-01

Configuring NetFlow-lite

Note NetFlow-lite is only supported on Catalyst 4948E and Catalyst 4948E-F Ethernet switches in IP Base or

higher.

This chapter describes how to configure NetFlow-lite, which provides traffic monitoring capabilities

similar to those provided through NetFlow.

The following topics are included:

• About NetFlow Packet Sampling, page 64-2

• Feature Interaction, page 64-2

• Configuring NetFlow Packet Sampling, page 64-2

• Display Commands, page 64-8

• Clear Commands, page 64-9

Note For complete syntax and usage information for the switch commands used in this chapter, see the Cisco

Catalyst 4500 Series Switch Command Reference and related publications at this location:

http://www.cisco.com/en/US/products/hw/switches/ps4324/index.html

If a command is not in the Catalyst 4500 Series Switch Command Reference, you can locate it in the

Cisco IOS library. See the Cisco IOS Command Reference and related publications at this location:

http://www.cisco.com/en/US/products/ps6350/index.html

Note VLAN monitors are not supported in Cisco IOS Release 15.0(2)SG.

Note Refer to the NetFlow Solutions Guide for more detailed information on NetFlow usage and management.

Other manuals for Cisco Catalyst 4500 Series