CHAPTER
59-1
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E
OL_28731-01
59
Configuring Wireshark
Beginning with Cisco IOS Release XE 3.3.0SG in the IP Base and Enterprise Services feature sets, the
Catalyst 4500 series switch supports Wireshark.
Note Wireshark is only supported on Supervisor Engine 8-E, Supervisor Engine 7l-E, Supervisor Engine 7-E,
Catalyst 4500X-16, and Catalyst 4500X-32.
Note Wireshark is supported on VSS and the functionality is the same as a standalone switch except for a few
configuration differences as detailed in the “Configuring Wireshark on VSS” section on page 59-14.
• Finding Feature Information, page 59-2
• Prerequisites for Wireshark, page 59-2
• Guidelines for Wireshark, page 59-2
• Restrictions for Wireshark, page 59-4
• Information about Wireshark, page 59-5
• How to Configure Wireshark, page 59-11
• Monitoring Wireshark, page 59-14
• Configuration Examples for Wireshark, page 59-15
• Usage Examples for Wireshark, page 59-18
• VSS Specific Examples, page 59-31
Note For complete syntax and usage information for the switch commands used in this chapter, see the Cisco
Catalyst 4500 Series Switch Command Reference and related publications at this location:
http://www.cisco.com/en/US/products/hw/switches/ps4324/index.html
If a command is not in the Catalyst 4500 Series Switch Command Reference, you can locate it in the
Cisco IOS library. See the Cisco IOS Command Reference and related publications at this location:
http://www.cisco.com/en/US/products/ps6350/index.html