Cisco Catalyst 4500 Series - Page 1579

63-17
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E
OL-28731-01
Chapter 63 Configuring SNMP
Displaying SNMP Status
Note You cannot use the snmp-server enable informs command. To enable the sending of SNMP inform
notifications, use the snmp-server enable traps command combined with the
snmp-server host host-addr informs command.
Table 63-4 Commands for Displaying SNMP Information
Feature Default Setting
show snmp
Displays SNMP statistics.
show snmp engineID
Displays information on the local SNMP engine and all
remote engines that have been configured on the device.
show snmp group
Displays information on each SNMP group on the network.
show snmp pending
Displays information on pending SNMP requests.
show snmp sessions
Displays information on the current SNMP sessions.
show snmp user
Displays information on each SNMP user name in the
SNMP users table.