Cisco Catalyst 4500 Series Administration Guide

71-12
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E
OL_28731-01
Chapter 71 Performing Diagnostics
seeprom: Pass
Traffic: L3 Looopback ...
Test Results: Pass
Traffic: L2 Loopback ...
Test Results: Pass
post done
Exiting to ios...
The following example shows the output from the show diagnositic result command for Supervisor
Engine 6-E and Supervisor Engine 6L-E:
Switch# show diagnostic result module 3 detail
module 3: SerialNo : XXXXXXXXXXX
Overall diagnostic result: PASS
Test results: (. = Pass, F = Fail, U = Untested)
___________________________________________________________________________
1) supervisor-bootup --------------->
Error code ------------------> 0 (DIAG_SUCCESS)
Total run count -------------> 1
Last test execution time ----> Oct 01 2007 17:37:04
First test failure time -----> n/a
Last test failure time ------> n/a
Last test pass time ---------> Oct 01 2007 17:37:04
Total failure count ---------> 0
Consecutive failure count ---> 0
Power-On-Self-Test Results for ACTIVE Supervisor
prod: WS-X45-SUP6-E part: XXXXXXXXX serial: XXXXXXXXXX
Power-on-self-test for Module 3: WS-X45-SUP6-E
Test Status: (. = Pass, F = Fail, U = Untested)
CPU Subsystem Tests ...
seeprom: Pass
Traffic: L3 Loopback ...
Test Results: Pass
Traffic: L2 Loopback ...
Test Results: Pass
Switching Subsystem Memory ...
Packet Memory Test Results: Pass
Module 3 Passed
___________________________________________________________________________
2) linecard-online-diag ------------>
Error code ------------------> 0 (DIAG_SUCCESS)
Total run count -------------> 1
Last test execution time ----> Oct 01 2007 17:37:04
First test failure time -----> n/a
Last test failure time ------> n/a
Last test pass time ---------> Oct 01 2007 17:37:04
Total failure count ---------> 0
Consecutive failure count ---> 0
Slot Ports Card Type Diag Status Diag Details
---- ----- -------------------------------------- ---------------- ------------
3 6 Sup 6-E 10GE (X2), 1000BaseX (SFP) Skipped Packet memory

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E