74-6
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E
OL_28731-01
Chapter 74 ROM Monitor
Exiting the ROM Monitor
Exiting the ROM Monitor
You must set the configuration register to a value from 0x2 to 0xF for the router to boot a Cisco IOS
image from flash memory upon startup or reloading.
The following example shows how to reset the configuration register and cause the router to boot a
Cisco IOS image stored in flash memory:
rommon 1 > confreg 0x2101
You must reset or power cycle for new config to take effect
rommon 2 >boot
The router will boot the Cisco IOS image in flash memory. The configuration register will change to
0x2101 the next time the router is reset or power cycled.
To Next Page
Loading...
