Cisco Catalyst 4500 Series - Page 265

5-49
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)SG
OL-30933-01
Chapter 5 Configuring Virtual Switching Systems
Configuring a VSS
Switch(config-if)# no ip address
Switch(config-if)# channel-group 1 mode desirable
Switch(config-if)# end
Note See the “Configuring a Range of Interfaces” section on page 8-4 for information about the range
keyword.
The following two examples show how to verify the configuration of GigabitEthernet interface 1/3/26:
Switch# show running-config interface gigabitEthernet 1/3/26
Building configuration...
Current configuration : 101 bytes
!
interface GigabitEthernet1/3/26
no switchport
no ip address
channel-group 1 mode desirable
end
Switch# show interfaces gigabitEthernet 1/3/26 etherchannel
Port state = Up Mstr In-Bndl
Channel group = 1 Mode = Desirable-Sl Gcchange = 0
Port-channel = Po1 GC = 0x00010001 Pseudo port-channel = Po1
Port index = 0 Load = 0x00 Protocol = PAgP
Flags: S - Device is sending Slow hello. C - Device is in Consistent state.
A - Device is in Auto mode. P - Device learns on physical port.
d - PAgP is down.
Timers: H - Hello timer is running. Q - Quit timer is running.
S - Switching timer is running. I - Interface timer is running.
Local information:
Hello Partner PAgP Learning Group
Port Flags State Timers Interval Count Priority Method Ifindex
Gi1/3/26 SC U6/S7 H 30s 1 128 Any 632
Partner's information:
Partner Partner Partner Partner Group
Port Name Device ID Port Age Flags Cap.
Gi1/3/26 3750x 2c54.2dd4.ad80 Gi1/0/25 20s SAC 50001
Age of the port in the current state: 0d:00h:04m:04s
Switch#
This example shows how to verify the configuration of port channel interface 1 after the interfaces have
been configured:
Switch# show etherchannel 1 port-channel
Port-channels in the group:
---------------------------
Port-channel: Po1
------------
Age of the Port-channel = 0d:00h:53m:41s
Logical slot/port = 21/1 Number of ports = 2
GC = 0x00010001
Passive port list = Gi1/3/26 Gi2/2/26
Port state = Port-channel L3-Ag Ag-Inuse
Protocol = PAgP