Cisco Catalyst 4500 Series - Page 27

Contents
27
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E
OL-30933-01
Configuring Layer 3 Interfaces 33-1
About Layer 3 Interfaces 33-1
Logical Layer 3 VLAN Interfaces 33-2
Physical Layer 3 Interfaces 33-2
Understanding SVI Autostate Exclude 33-3
Understanding Layer 3 Interface Counters 33-3
Configuration Guidelines 33-5
Configuring Logical Layer 3 VLAN Interfaces 33-6
Configuring VLANs as Layer 3 Interfaces 33-7
Configuring SVI Autostate Exclude 33-7
Configuring IP MTU Sizes 33-9
Configuring Layer 3 Interface Counters 33-10
Configuring Physical Layer 3 Interfaces 33-12
Configuring EIGRP Stub Routing 33-13
About EIGRP Stub Routing 33-13
Configuring EIGRP Stub Routing 33-14
Dual-Homed Remote Topology 33-15
EIGRP Stub Routing Configuration Tasks 33-18
Monitoring and Maintaining EIGRP 33-19
EIGRP Configuration Examples 33-19
Route Summarization Example 33-19
Route Authentication Example 33-20
Stub Routing Example 33-20
Configuring Cisco Express Forwarding 34-1
About CEF 34-1
CEF Features 34-1
Forwarding Information Base 34-2
Adjacency Tables 34-2
Adjacency Discovery 34-2
Adjacency Resolution 34-2
Adjacency Types That Require Special Handling 34-3
Unresolved Adjacency 34-3
Catalyst 4500 Series Switch Implementation of CEF 34-3
Hardware and Software Switching 34-4
Hardware Switching 34-5
Software Switching 34-5
Load Balancing 34-6
Software Interfaces 34-6