Cisco Catalyst 4500 Series - Page 785

28-11
Software Configuration Guide—elease IOS XE 3.6.0E and IOS 15.2(2)E
OL_28731-01
Chapter 28 Configuring IPv6 Multicast Listener Discovery Snooping
Displaying MLD Snooping Information
Table 28-2 Commands for Displaying MLD Snooping Information
Command Purpose
show ipv6 mld snooping [vlan vlan-id]
Displays the MLD snooping configuration information for all VLANs
on the switch or for a specified VLAN.
(Optional) Enter vlan vlan-id to display information for a single VLAN.
The VLAN ID range is 1 to 1001 and 1006 to 4094.
show ipv6 mld snooping mrouter [vlan
vlan-id]
Displays information on dynamically learned and manually configured
multicast router interfaces. When you enable MLD snooping, the switch
automatically learns the interface to which a multicast router is
connected. These are dynamically learned interfaces.
(Optional) Enter vlan vlan-id to display information for a single VLAN.
The VLAN ID range is 1 to 1001 and 1006 to 4094.
show ipv6 mld snooping querier [vlan
vlan-id]
Displays information about the IPv6 address and incoming port for the
most-recently received MLD query messages in the VLAN.
(Optional) Enter vlan vlan-id to display information for a single VLAN.
The VLAN ID range is 1 to 1001 and 1006 to 4094.