Cisco Catalyst 4500 Series Administration Guide

31-13
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E
OL_28731-01
Chapter 31 Configuring LLDP, LLDP-MED, and Location Service
Configuring LLDP and LLDP-MED, and Location Service
Use the no form of each command to return to the default setting.
This example shows how to configure civic location information on the switch:
Switch# configure terminal
Switch(config)# location civic-location identifier 1
Switch(config-civic)# number 3550
Switch(config-civic)# primary-road-name "Cisco Way"
Switch(config-civic)# city "San Jose"
Switch(config-civic)# state CA
Switch(config-civic)# building 19
Switch(config-civic)# room C6
Switch(config-civic)# county "Santa Clara"
Switch(config-civic)# country US
Switch(config-civic)# end
To enable location service on the switch, perform this task:
Note Your switch must be running the cryptographic (encrypted) software image in order to enable the
location service feature. Your Cisco Mobility Service Engine (MSE) must be running Heitz 6.0 or later
software image to support wired location service
Step 5
Switch(config-if)# location
{additional-location-information word |
civic-location-id id | elin-location-id
id}
Enters location information for an interface:
additional-location-information—Specifies additional information
for a location or place.
civic-location-id—Specifies global civic location information for an
interface.
elin-location-id—Specifies emergency location information for an
interface.
id—Specifies the ID for the civic location or the ELIN location. The
ID range is 1 to 4095.
word—Specifies a word or phrase that provides additional location
information.
Step 6
Switch(config-if)# end
Returns to privileged EXEC mode.
Step 7
Switch# show location
Verifies the configuration.
Step 8
Switch# copy running-config
startup-config
(Optional) Saves your entries in the configuration file.
Command Purpose
Command Purpose
Step 1
Switch# configure terminal
Enters global configuration mode.
Step 2
Switch(config)# nmsp enable
Enables the NMSP features on the switch.
Step 3
Switch(config)# ip device tracking
Enables IP device tracking.

Cisco Catalyst 4500 Series Specifications

General

Series	Catalyst 4500 Series
Category	Switch
Layer Support	Layer 2, Layer 3
Form Factor	Modular chassis
Stackable	No
Chassis Slots	3, 6, 7, 10
Power Supply Options	AC, DC
Redundancy	Power supply, Supervisor engine
Network Management	Cisco IOS Software CLI, SNMP, Cisco Prime Infrastructure
Features	Security, QoS
Port Density	Up to 384 ports per chassis
Security Features	802.1X, ACLs, DHCP Snooping, Dynamic ARP Inspection, IP Source Guard
Supervisor Engine	8-E