Comtech EF Data CDM-570AL - Page 225

CDM-570A/570AL Satellite Modem with Optional Packet Processor
Revision 5
Ethernet-based Remote Product Management 7–37 MN-CDM570A
Figure 7-20. Configuration | Routing | Routes Page
Route Table (Edit)
This section displays and allows you to edit all current Route Table entries. From left to right:
Column
Description
Index
This is the internal table index that is automatically assigned and cannot be edited.
Name
This label helps to maintain the network. Enter a label string in this text box. The assigned
name must be unique and cannot contain any whitespace.
Dest.IP/Mask
Enter a Destination IP Address/Mask in the form XXX.XXX.XXX.XXX/YY.
Interf.
Use the drop-down list to select the Interface as toEth or toSat.
Next Hop IP
Enter the desired Next Hop IP Address for toEth routes. Note that no Next Hop entry is
needed for toSat routes.
Next Hop
HDLC
Displays the desired Next Hop HDLC IP Address for traffic to be sent over the satellite,
within the following ranges:
• Point-to-Point: No HDLC address
• Small Network: 0x1 – 0xFE
• Large Network: 0x1 – 0x7FFE
Multicast
Options
Use the drop-down list to select the Multicast Option as noRouting, ethToSatRouting,
satToEthRouting, or satToEthAndEthToSatRouting.
Header Comp.
When the optional Header Compression FAST feature is available, use the drop-down list to
Disable or Enable operations.
Payload Comp.
When the optional Payload Compression FAST feature is available, use the drop-down list to
Disable or Enable operations.