CDM-570A/570AL Satellite Modem with Optional Packet Processor
Revision 5
ODU (Transceiver, BUC, LNB) Operation 10–19 MN-CDM570A
(KST CONFIG: ► KST TX:) HPA
HPA: State Fault-Logic
(◄ ►,ENT)
Use the ◄ ► arrow keys to select State or Fault-Logic, and then press ENTER.
(KST CONFIG: ► KST TX:) HPA ► State
KST HPA State:
On Off (◄ ►,ENT)
Use the ◄ ► arrow keys to select On or Off, and then press ENTER.
If the HPA power is Off, it cannot report errors, answer messages,
provide serial numbers, etc.
(KST CONFIG: ► KST TX:) HPA ► Fault-Logic
HPA Fault Logic: Summary
No-Summary (◄ ►,ENT)
To control whether or not HPA fault will activate the SUMMARY FAULT RELAY, use the
◄ ► arrow keys to select Summary or No-Summary. Press ENTER when done.
10.2.1.2.2.1.1.2 (KST SELECT: ► KST CONFIG:) Receiver
KST RX: Frequency Atten
LNA (◄ ►,ENT)
KST RX: Frequency Atten
LNB (◄ ►,ENT)
Use the ◄ ► arrow keys to select Frequency, Atten, or LNA/LNB, and then press ENTER.
(KST CONFIG: ► KST RX:) Frequency
ODU Rx Frequency:
10950.0 MHz (◄ ►,▲ ▼,ENT)
To edit the receive frequency, first use the ◄ ► arrow keys to select a digit, and then use the
▲▼arrow keys to change the value of that digit. Press ENTER when done.
(KST CONFIG: ► KST RX:) Atten (Attenuation)
ODU Rx Attenuation:
15 dB (◄ ►,▲ ▼,ENT)
To edit the receive attenuation, first use the ◄ ► arrow keys to select a digit, and then use
the ▲▼arrow keys to change the value of that digit. Press ENTER when done.
(Displayed when ODU is a KST-2000A unit)
(Displayed when ODU is a KST-2000B unit)
To Next Page
Loading...
