EasyManua.ls Logo

Comtech EF Data CDM-570AL - Page 227

Default Icon
682 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CDM-570A/570AL Satellite Modem with Optional Packet Processor
Revision 5
Ethernet-based Remote Product Management 7–39 MN-CDM570A
CDM-570A as Client
Recognize IGMP Queries Use the drop-down list to select No or Yes.
IGMP Version for Unsolicited Reports Use the drop-down list to select V1 or V2.
Unsolicited Report IntervalThis is the maximum response time inserted into group-
specific queries that are set in response to Leave Group messages, and it is also the
amount of time between group-specific query messages. This value may be tuned to
modify the "leave latency" of the network; a reduced value results in reduced time to
detect the loss of the last member of a group.
Enter a value, in seconds, from 1 to 25 (default = 1 second).
Force Router Alert Option Sending V1 ReportsUse the drop-down list to select No
or Yes.
CDM-570A as Server
Enable IGMP Use the drop-down list to select No or Yes.
IGMP Version for Unsolicited Reports Use the drop-down list to select V1 or V2.
IGMP Query Period This is the interval between general queries sent by the modem.
By varying the query interval, a modem administrator may tune the number of IGMP
messages on the subnet; note that larger numbers cause the IGMP queries to be sent
less often.
Enter a value, in seconds, from 1 to 600.
IGMP Maximum Response Time – This is the maximum response time inserted into the
periodic general queries. By varying the Query Response Interval, a modem
administrator may tune the “burstiness” of IGMP messages on the subnet; note that
larger values make the traffic less “bursty” as host responses are spread out over a large
interval.
Enter a value, in seconds, from 1 to 30.
The number of seconds assigned to the Query Response Interval must be
less than the Query Interval.
Click [Submit] to save.
IGMP Table
This read-only table displays the Multicast Routes that are active on the modem.
Click [Refresh] to update this section with its latest available information.
Make sure to also click [Save PaP Parameters] on the ‘Admin | PaP Save’ page
before proceeding further.

Table of Contents

Related product manuals