Comtech EF Data CDM-570AL - Page 282

CDM-570A/570AL Satellite Modem with Optional Packet Processor
Revision 5
Serial-based Remote Product Management 8–16 MN-CDM570A
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments for
Command or
Response to
Query
Description of Arguments
Response to
Command
Query
(Instruction Code
and Qualifier)
Response to
Query
Power Level
Mode
AUP=
1 byte,
value of 0, 1, 2
Command or Query.
Sets or returns Power level mode in the form x, where:
0 = MANUAL mode (Normal power mode)
1 = AUPC enabled.
2 = CnC APC enabled
Notes:
1. EDMAC framing and/or IP-ACM must be selected for the AUPC feature to work.
2. CnC APC will be forced to enable when CnC is in APC mode (CNM=2 ..9)
Example: <0/AUP=1
AUP=
AUP?
AUP*
AUP#
AUP?
AUP=x
(see Description of
Arguments)
AUPC Parameters
APP=
6 bytes
Command or Query.
Not valid in Manual mode.
Sets or returns AUPC operating parameters, in the form abc.cd, where:
a = Defines action on max. power condition.
0 = do nothing
1 = generate Tx alarm
b = Defines action on remote demod unlock.
0 = go to nominal power
1 = go to max power
c = Target E
b
/N
0
value, for remote demod, from 0.0 to 14.9 dB, where numbers >9.9
use hex representation for the 1 st character, i.e., 14.9 is coded as E.9.
d = Max increase in Tx Power permitted, from 0 to 9 dB
Example: <0/APP=015.67 (Sets no alarm, max power, 5.6 dB Target and 7 dB power
increase.)
In IP-ACM mode:
a=Defines action on max. power condition.
0 = do nothing
1 = generate Tx alarm
2=generate Tx alarm when mimimum ModCod is reached
b=Defines action on remote demod unlock.
0 = go to nominal power
1 = go to max power
2=hold
c = Max increase in Tx Power permitted, from 0.0 to 9.9 dB OR when CnC mode is
on, from 0.0 to 3.0 dB
d = unsued (always 0)
APP=
APP?
APP*
APP#
APP?
APP=abc.cd
(see Description of
Arguments)