Comtech EF Data CDM-570AL - Page 536

CDM-570L/570AL Satellite Modem with Optional Packet Processor
Revision 5
Optional High Performance Packet Processor D–30 MN-CDM570A
Next, do these steps on CDM-IP 2 (the applicable CLI “hot key” is shown in brackets [#]):
Step
Task
8
From Transmitter Configuration Main Menu submenu select Route Table [R] submenu.
9
Enter 1 to configure the first route.
10
Enter a suitable name
11
Set IP Address to 172.17.10.0
12
Set Number of Subnet Bits to 24
13
For Interface to which route is destined to <E-Ethernet S-Satellite Enter : S> select S
14
CDM-IP 2 Route Table should display the following:
Route Name Dest IP/SNet Bits Next Hop MultiCast State
Route001...[test 172.17.10.0/24 POINT-TO-POINT N/A toSat]
At this point the basic configuration is complete and you should be able to:
• Ping User PC 1 from User PC 2, and User PC 2 from User PC 1;
• Ping CDM-IP 2 from User PC 1, and User PC 1 from CDM-IP 2;
• Pass any other data between the 2 PCs
Do these steps to finish:
Step
Task
15
From PC1:
• Ping 172.17.10.1 (CDM-IP 1)
• Ping 172.16.10.1 (CDM-IP 2)
• Ping 172.16.10.11 (PC 2)
16
From PC2:
• Ping 172.16.10.1 (CDM-IP 2)
• Ping 172.17.10.1 (CDM-IP 1)
• Ping 172.17.10.11 (PC 1)