Field Service Ver. 1.0 Aug. 2005 9. Utility/Counter Mode
125
bizhub 200/250/350Adjustment / Setting
9.4 Settings in the User Management
9.4.1 Confirmation Beep
9.4.2 Alarm Volume
9.4.3 Job Complete Beep
9.4.4 Panel Cleaning
9.4.5 Dehumidify
Functions • To set whether or not to produce a sound when a key in the Keypad is pressed.
Use • To change whether or not to produce a sound when a key in the Keypad is pressed.
Setting/
Procedure
• The default setting is “3”.
0 to 5
Functions
• To specify the volume of the alarm that sounds when an error occurs or an incorrect
operation is specified.
Use
• To change the volume of the alarm that sounds when an error occurs or an incorrect
operation is specified.
Setting/
Procedure
• The default setting is “3”.
0 to 5
Functions • To set the volume of the beep that sounds when a job is completed.
Use • To change the volume of the beep that sounds when a job is completed.
Setting/
Procedure
• The default setting is “3”.
0 to 5
Functions • To disable control panel key operations.
Use • To disable control panel keys before cleaning the display on the control panel.
Setting/
Procedure
• To cancel this function, press the Panel Reset key to display the Basics screen.
Functions
• To dehumidify the Scanner when dew condensations are formed on the Scanner
because of sudden changes in temperature or high humidity.
Use
• To prevent dew condensations from being formed on the Photo Conductor during
changes in ambient conditions.
Setting/
Procedure
• When [Dehumidify] is touched, the Photo Conductor or Exposure Lamp is operated for
a predetermined period of time and then stops in the mode set by the corresponding
Tech. Rep. Choice function.
To Next Page
Loading...
