11. Tech. Rep. Mode Field Service Ver. 1.0 Aug. 2005
190
bizhub 200/250/350
Adjustment / Setting
<Authentication Setting>
(4) TX/RX Test
(5) Initial data
Functions
• To set whether or not to enable authentication during transmission via the SMTP
server.
Use
• Use to enable authentication during transmission.
Types of authentication to be set: POP Before SMTP, SMTP authentication
Setting/
Procedure
• The default setting is “OFF”
ON “OFF”
* If POP Before SMTP is set, make the setting for POP Before SMTP.
• The default setting is “60 sec”
“60 sec” (0 to 60)
* If SMTP authentication is set, make the following settings.
User ID: Enter the user ID for SMTP authentication.
Password: Enter the password for SMTP authentication.
Functions • To carry out the transmission/reception tests for CS Remote Care.
Use • To carry out the transmission/reception tests for CS Remote Care.
Setting/
Procedure
• Press the Start key to start transmission.
• The test progress and results are displayed on the screen.
Functions • To initialize server settings.
Use • To initialize server settings.
Setting/
Procedure
• The default setting is “NO”
YES “NO”
To Next Page
Loading...
