Instructions for Use Fabius MRI SW 3.n 41
Operation Concept
Soft Keys
The functions of the six soft keys located below the
the screen are indicated by the labels shown above
each key. The labels change depending on the cur-
rent mode:
1 In Standby mode, the following soft key labels
appear at the bottom of the Standby screen:
–»Run System Test«
–»Calibrate Flow Sensor«
–»Calibrate O2 Sensor«
–»Leak / Compl Test«
–»Access Alarm Log«
–»Restore Site Defaults«
See “Configuration Functions in Standby Mode” on
page 132 for complete information.
2 In any ventilation mode, the soft keys labels
show the ventilation parameters and functions
that are available in that particular ventilation
mode (Volume Control mode parameters are
shown in the example illustration).
3 If the »Setup« key is pressed in any ventilation
mode, the following soft keys appear at the bot-
tom of the screen:
–»Volume Alarms On/Off«
–»Auto Set«
–»Calibrate O2 Sensor«
–»Des Comp On/Off«
–»Access Alarm Log«
–»Access Alarm Volume«
See “Configuration during Operation” on page 152
for complete information.
NOTE
The »Volume Alarms On/Off« soft key label does
not appear in ManSpont mode because it is select-
able on the ManSpont screen.
To Next Page
Loading...
Need help?
General
