Programming
Service Instructions 755 A/756 A - 00.0 - 02/2019 361
Setting needle thread-clamp/-catcher/-tension
The display switches to Needle thread-clamp/-catcher/
-tension.
Fig. 332: Setting needle thread-clamp/-catcher/-tension
To set the needle thread clamp, the needle thread catcher and the needle
thread tension:
1. Press the desired button.
2. Enter the desired value using the numeric keypad.
3. Confirm with OK.
Symbol Meaning
Set time: loosen needle thread clamp (seam beginning)
•0ms - 1000ms
Set seam end: mm till thread clamp opens
• 0 mm - 100 mm
Set mm with needle thread catcher open
• 0 mm - 50 mm
To Next Page
Loading...
