DURKOPP ADLER 755 A

Troubleshooting
Service Instructions 755 A/756 A - 00.0 - 02/2019 459
3501 The X and Y position are out of
min/max range
Change seam contour
3502 The X and Y position are within
forbidden area
Change seam contour
3503-3507,
3520-3530,
• Error Command Interpreter
• Motor synchronization Internal
error
• Switch off and on the machine
again
• Perform software update
 p. 431
• Feedback to Dürkopp Adler
Service
3522 Error Command Interpreter/Motor
synchronization Internal error
• Switch off and on the machine
again
• Perform software update
 p. 431
• Feedback to Dürkopp Adler
Service
3540,
3545
• Error Command Interpreter
• Motor synchronization Internal
error
• Switch off and on the machine
again
• Perform software update
 p. 431
• Feedback to Dürkopp Adler
Service
3721, 3722 • Error Command Interpreter
• Motor synchronization Internal
error
• Switch off and on the machine
again
• Perform software update
 p. 431
• Feedback to Dürkopp Adler
Service
Error code 4000-4999: Error messages USB
4200 Machine configuration adopted
from the USB file
Check machine configuration
4301 No USB key at the control unit Insert USB key
4304 Wrong USB key Replace USB key
4681 No communication with DAC • Check cable connection
• Check OP7000 cable at socket
X170b
• Check DAC blink codes
4682 No active seam program from
DAC
• Check communication
• Change seam program
• Delete seam program
• Empty sequences
Error code Symbol Meaning Remedial action