DURKOPP ADLER 755 A

Troubleshooting
460 Service Instructions 755 A/756 A - 00.0 - 02/2019
4683 No valid sequence number • Check communication
• Change sequence
• Compare software version of DAC
and OP7000
Error code 5000-5999: Error messages machine configuration
5108 - Use USB file from this machine.
5201 Error step motor corner knife,
slanted seam end
• Check cable to reference switch
• Check reference switch
• Check motor for stiff movement
5202 Error step motor corner knife,
slanted seam beginning
• Check cable to reference switch
• Check reference switch
• Check motor for stiff movement
5203 Error step motor corner knife,
angle seam begin right
• Check cable to reference switch
• Check reference switch
• Check motor for stiff movement
5204 Error step motor corner knife,
angle seam begin left
• Check cable to reference switch
• Check reference switch
• Check motor for stiff movement
5205 Error step motor corner knife,
angle seam end right
• Check cable to reference switch
• Check reference switch
• Check motor for stiff movement
5206 Error step motor corner knife,
angle seam end left
• Check cable to reference switch
• Check reference switch
• Check motor for stiff movement
5209 Error horizontal step motor mark-
ing lamp
• Check cable to reference switch
• Check reference switch
• Check motor for stiff movement
5210 Error vertical step motor marking
lamp
• Check cable to reference switch
• Check reference switch
• Check motor for stiff movement
Error code Symbol Meaning Remedial action