DURKOPP ADLER D867 M-Type Delta

Programming
Service Instructions M-TYPE DELTA - 00.0 - 12/2019 155
• Clean remaining thread monitor
• Bartack suppression LED
•2
nd
stitch length LED
•2
nd
needle thread tension LED
•2
nd
sewing foot stroke LED
• Center guide LED
• Raise/lower center guide
• Motor running
•2
nd
edge Guide Position
• NSB exhaust
• Puller LED
• Pressure Puller
• Raise/lower puller
• Bartacking in process
• In seam
• Segment Output 01
• Segment Output 02
• Segment Output 03
• Segment Output 04
• Segment Output 05
• Segment Output 06
• Segment Output 07
• Segment Output 08
• Segment Output 09
• Segment Output 10
• Segment Output 11
• Segment Output 12
• Segment Output 13
• Segment Output 14
• Segment Output 15
• Segment Output 16
• Manual bartack
• Stitch done
• Motor blockage (operation lock)
• Short stitch
• Edge guide
• Machine arm lighting
• Function module output 1
• Function module output 2