User Manual Section 6
GFK-2958L May 2021
Installation 410
Figure 244: Sliding the Module into Position
6.
Attach all the other modules as described above.
7.
Connect the second end bracket to the end plate as specified by the alignment pins.
8.
Place both parts on the DIN rail on the right-hand side of the station so that the end
bracket faces outwards.
9.
Slide the end bracket and end plate to the left until it completely connects with the
last module.
Figure 245: Sliding the End Plate with End Bracket into Position
10.
Screw down the end bracket tightly (using a 3-mm screwdriver).
11.
Make sure that all release levers are in the locking position as standard. If this is not
the case, click the open release lever into place.
To Next Page
Loading...
