EPSON EPL-N4000/EPL-N4000+ Chapter 2 Operating Principles
Rev.B 87
2.7.2 Controller
The video data from the host computer is input to the controller circuit
throu
h either interface circuit or network board. C262 Main Board,
which is the control circuit of this printer,
the data based on the printin
data from the host computer
into the laster data. Laster data is sent to Laser Diode PWB as video
si
nal. On the Laser Diode PWB, the emission li
ht of Laser Diode is
turned on or off by the video si
nal.
2.7.2.1 Functions of the Controller
Communication between the host computer and network
Processin
nal to ROS Assembly
Monitorin
the control panel
Memory Mana
ement
Data Buffer
2.7.2.2 Specification on the Controller
The table below shows specifications on the controller.
Table 2-1. Specification on the Controller
Type Name (Location) Function
CPU R4700(IC1) CPU controls the controller and is driven b
64 bit interior clock 133 MHz.
ASIC E05B51 (IC2) Memor
control and DMA control.
E05B52 (IC23) Connectin
E05B51 and E05B40
E05B40 (IC26) Control Panel, Host I/F control
E05B56 (IC32) PGI, RIT, En
ine I/F, Toner Counter
Memor
Mask ROM(IC10,
11) / Flash ROM
(CN4,7)
IPL/Font
ROM DIMM Code, Local lan
e and Expansion ROM
DRAM SDRAM DIMM is used for both Standard and
Expansion.
EEPROM(IC405) 128kbit Serial t
values
of the printer.
EEPROM 64Kbit, Parallel T
pattern)
Host I/F Parallel I/F IEEE-1284, B-t
pe connector
Network 10/100 BaseT
Control Panel Control Panel Unit LCD(20x1), 8 SWs, 6 LEDs
Expansion ROM Expansion b
Ch1
Hard Disk P Bus (No DMA)
ROM Bus Expansion for ROM and I/F
Clock CPU 66.66660 MHz
Video 67.1749 MHz
Dot 33.58748 MHz
DMA Video. Color PCI (CPU Bus)
Video. Monochrome E05B56
I/O E05B52 via E05B40 + T