Epson EPL-N4000 - Tray 1 Lift up Motor; Removal; Installation

EPSON EPL-N4000/EPL-N4000+ Chapter 4 Disassembly and Assembly
Rev.B 144
4.2.7 Tray 1 Lift Up Motor
(See “Tray Interface -Tray 1” on pa
g
e -258)
4.2.7.1 Removal
1. Slide Tray 1 halfway out of the printer.
2. Remove the Rear Cover. (“Rear Cover Assembly” on pa
g
e -140)
3. Disconnect the J203 from the rear of Tray 1 Lift Up Motor.
4. Remove the three lon
g
screws securin
g
the Motor to the printer
frame.
5. Slide the Motor out to remove it.
Figure 4-14. Removal of Tray 1 Lift Up Motor
4.2.7.2 Installation
1. Reinstall the Lift Up Motor onto the printer frame. Be careful not to
trap any wires between the Motor and the frame.
2. Use three lon
g
screws to secure the Motor to the frame. Use one
screw on the lower left and two screws on the ri
g
ht side of the
Motor.
3. Reconnect J203 to the rear of the Lift Up Motor.
4. Reinstall the Rear Cover. (“Rear Cover Assembly” on pa
g
e -140)
5. Slide Tray 1 into the printer.