Epson EPL-N4000 - Installation

EPSON EPL-N4000/EPL-N4000+ Chapter 4 Disassembly and Assembly
Rev.B 199
4.2.50.2 Installation
1. Reinstall the Fuser Drive Assembly onto the printer frame. (Refer to
the fi
g
ure for correct positionin
g
)
2. Ali
g
n the Assembly so the screw holes and locatin
g
holes in the
Assembly line up with the screw holes and locatin
g
tabs on the
frame.
3. Use two screws to secure the Assembly to the frame.
4. Reinstall the
g
reen
g
round wire to the printer frame, and use one
screw to secure the wire.
5. Reconnect J104, J600, and J602.
6. Reinstall P204 wire harness to the Fuser Drive Assembly.
7. Reconnect FB (red wire) to the HVPS and secure the wire harness
under the harness clips.
8. Reconnect J23 to the AC Driver PWB and secure the wire harness
under the harness clips.
9. Reinstall the Offset Unit Assembly. (“Offset/Exit Assembly” on
pa
g
e -200)
10. Reinstall the EP Cartrid
g
e. (“EP Cartrid
g
e (Toner Cartrid
g
e)” on
pa
g
e -192)
11. Reinstall the Fuser Assembly. (“Fuser Assembly” on pa
g
e -197)