EPSON EPL-N4000/EPL-N4000+ Chapter 4 Disassembly and Assembly
Rev.B 143
4.2.6 Rear Cover 1TM
(See “Rear, Left and Ri
e -255)
4.2.6.1 Removal
1. Disconnect all option plu
Jack located at the rear of
the printer.
2. Remove the two screws securin
the Rear Cover 1TM to the printer
frame.
3. Lift up on the Cover and remove it from the printer frame.
Figure 4-13. Removal of Rear Cover 1TM
4.2.6.2 Installation
1. Reinstall the Rear Cover 1TM by first hookin
e of
the Cover onto the frame, then pressin
ainst
the frame.
2. Use two screws to secure the Cover to the printer frame.
3. Reconnect the option plu
Jack located at the rear of
the printer.
To Next Page
Loading...
