Epson EPL-N4000 - Tray1 & Tray 2 no Paper Sensors; Removal; Installation

EPSON EPL-N4000/EPL-N4000+ Chapter 4 Disassembly and Assembly
Rev.B 157
4.2.16 Tray1 & Tray 2 No Paper Sensors
(See “Tray Interface -Tray 1” on pa
g
e -258 and “Tray Interface-Tray 2”
on pa
g
e -261)
Use this procedure for removin
g
and reassemblin
g
the No Paper
Sensors for Trays 1 and 2.
4.2.16.1 Removal
1. Remove the Paper Tray associated with the No Paper Sensor you
are
g
oin
g
to remove.
2. Squeeze the Sensor latches and remove the No Paper Sensor from
the frame.
3. Disconnect the P/J from the Sensor.
4.2.16.2 Installation
1. Reconnect the P/J to the Sensor.
2. Push the No Paper Actuator up and out of the way.
3. Position the Sensor with the arms of the Sensor facin
g
the Actuator.
4. Reinstall the No Paper Sensor into the slot in the frame by first
insertin
g
the front latch of the Sensor throu
g
h the front openin
g
in
the frame.
5. Press in on the rear latch and insertin
g
it into the rear openin
g
.
6. Release the rear latch and the Sensor snaps into place.
7. Release the Actuator and make sure it moves freely between the
arms of the Sensor.
8. Reconnect the P/J to the Sensor.
9. Reinstall the Paper Tray.
Figure 4-25. Removal of No Paper Sensor