Epson EPL-N4000 - Tray 2 Feeder Assembly; Removal

EPSON EPL-N4000/EPL-N4000+ Chapter 4 Disassembly and Assembly
Rev.B 160
4.2.19 Tray 2 Feeder Assembly
(See “Paper Pick Up - Tray 1” on pa
g
e -259)
4.2.19.1 Removal
1. Tray 2 from the printer.
2. Remove the Rear Cover. (“Rear Cover Assembly” on pa
g
e -140)
3. Remove the Front Chute. (“Tray 1&2 Front Chute Assemblies” on
pa
g
e -155)
4. Remove Tray 2 Feed Clutch alon
g
with the Feed Gear and Bearin
g
.
(“Tray 2 Feed Clutch” on pa
g
e -159) (Refer to the fi
g
ure on your
ri
g
ht).
5. Remove the E rin
g
that is securin
g
the Feed Gear (located behind
the Feed Clutch) to the shaft, and remove the Feed Gear and
Bearin
g
.
6. Hold down the Stopper Link while you pull the Feeder Assembly to
the front of the printer frame.
7. Remove the Feeder Assembly from Feeder 2.
Figure 4-29. Removal of Tray2 Feeder Assembly
CAUTION
Take care not to break or dislodge the NO Paper
Actuator when removing or replacing the Tray2
Feeder Assembly.