Epson EPL-N4000 - Tray 2 Take Away Sensor; Removal; Installation

EPSON EPL-N4000/EPL-N4000+ Chapter 4 Disassembly and Assembly
Rev.B 183
4.2.37 Tray 2 Take Away Sensor
(“Tray 2 Frame and Left Cover” on pa
g
e -270)
4.2.37.1 Removal
1. Open the Left Lower Cover.
2. Squeeze in all four Sensor latches while you pull the Sensor out of
the printer frame.
3. Disconnect J143 from the Sensor.
Figure 4-52. Removal of Tray2 Take Away Sensor
4.2.37.2 Installation
1. Reconnect J143 to the Sensor.
2. Insert the Sensor into the cutout in the frame. (See the fi
g
ure for
correct positionin
g
).
3. Press in on the Sensor until it snaps into place.
4. Close the Left Lower Cover.